Headstock thread adaptor. To fit onto a lathe with 3/4″ x 10tpi headstock thread. To mount a scroll chuck (or face plate) with M33 x 3.5mm thread....

Woodturners drill chuck. 13mm diameter drilling capacity, with No.1 Morse taper (MT1) fitting.Supplied with chuck key.

Woodturners drill chuck. 16mm diameter drilling capacity, with No.2 Morse taper (MT2) fitting.Supplied with chuck key.

Turn spindles without removing your chuck from the lathe using this four prong drive centre. The centre point insert is removable and can be replac...

Turn spindles without removing your chuck from the lathe using this chuck drive centre. The sharp point in the centre is spring loaded and retracts...

1 Morse Taper Crown Drive Centre. Our Crown centres feature a set of sharp teeth that bite into the wood to give a more secure hold than traditiona...

2 Morse Taper Crown Drive Centre.Our Crown centres feature a set of sharp teeth that bite into the wood to give a more secure hold than traditi...

Turn spindles without removing your chuck from the lathe using this chuck drive centre. The sharp point in the centre is spring loaded and retracts...

SIP Outboard turning attachment to fit the 01939/40 Lathes extends bowl turning capacity on SIP 01949 and 01939 wood lathes. Specification: Dur...

Headstock thread adaptor. To fit onto a lathe with 1″ x 8tpi headstock thread. To mount a scroll chuck (or face plate) with M33 x 3.5mm thread. Sui...

Headstock thread adaptor. To fit onto a lathe with M33 x 3.5mm headstock thread. Suitable to mount a Scroll Chuck or Faceplate with a 1″ x 8tpi th...

Headstock thread adaptor. To fit onto a lathe with 1″ x 10tpi headstock thread. To mount a scroll chuck (or face plate) with M33 x 3.5mm thread. S...

The Faithfull Chisel Roll is made from a hard wearing nylon backed polyester material which is double stitched at stress points and edged for extra...